Construction Code piling work: 1, is not fully reliable place before the completion of the preparatory work and are not allowed to start the diesel hammer, diesel hammer should ensure that no foreign objects inside, to prevent accidents. 2, when the lower piston extends downward, not allowed to start the diesel hammer injection pump, in order to prevent damage to the connection flange and the lower cylinder. 3, diesel pile hammer from the frame rails or parked on the skids supporting the high-pressure injection pump Jet, are not allowed to start the diesel hammer. 4, should take measures to prevent playing eccentric pile, if found during construction must be corrected immediately. 5, if the piston every 10 times against high-pressure injection pump grouting pump, pile sinking of the total (ie, the degree of penetration) is less than 20mm, it must stop immediately, otherwise it can easily cause fatigue fracture under the piston. 6, if the penetration of the pile becomes smaller, should be checked on the piston rebound is too high, and regulating every diesel hammer blow energy or parking. 7, always check the diesel hammer guide plate, landing gear attachment bolts guide block, according to the provisions of twisting torque requirements tighten. Diesel hammer guide plate, the guide portion of the landing gear guide block wear or deformation must be replaced immediately. 8 Do not use rail deformation or excessive wear of the pile frame, in order to avoid accidents. 9, piling operations must strictly abide by the "diesel hammer Manual" specified tilt range. 10, diesel pile hammer or signs of damage or damaged, you must immediately stop. The company operating the rig Jet Jet rigs and accessories, complete sets of high spray equipment, high-pressure injection pump and accessories, high-spray trolley two liquid injection pump Triplex picture, double-barreled drill, drill three sets of products, professional high-pressure pipe ram service.